ABS-like Fast Resin TDS for Basic Fast

This TDS is for Fast Creamy/Grey/White/Navy Grey/Green/Metal Grey/Smoky Black. 

Other information you might also need:

1. Product Introduction

  • Good fluidity for faster printing and a higher success rate
  • Tough and not fragile, can withstand accidental falls
  • Easy to clean, reducing printing time
  • Excellent detail, precise printing

Application:

  • Great for general printing
  • Tabletop miniatures
  • Digital sculptures
  • Model Making

2. Property Data

Mechanical Properties

Measure

Method

Tensile Stress at Yield (Mpa)

64

ASTM D638

Tensile Stress at Break (%)

60

ASTM D638

Young’s Modulus (Mpa)

1700

ASTM D638

Elongation at Break (%)

18

ASTM D638

Flexural Modulus (Mpa)

2400

ASTM D790

IZOD Impact (Notched) J

25

ASTM D256

Shore Hardness D

75

ASTM D2240


Other Properties

Measure

Method

HDT at 0.455 MPa

65

ASTM D648

Solid Density (g/cm3)

1.2

ASTM 792

Water Absorption (24hr) (%)

0.75%

ASTM D570

 

Liquid Properties

Measure

Method

Viscosity at 25°C (77°F)

110

ASTM D7867

Liquid Density

1.1

ASTM D1475

 

3. Work Flow

  • Printing

Fast Resin by Siraya Tech is a premium 3D printing material that offers fast printing and curing times, low odor, and easy cleaning. With high precision and detail retention, it's ideal for intricate designs. Perfect for prototyping and production, it's a top choice for hobbyists, artists, and beginners alike.

Fast Navy Grey requires 20% more exposure time than other regular Fast.

Fast Navy Grey and Fast Creamy have heavy pigments for a smooth matte look. Shake hard before opening to prevent white clusters from settling.

 To achieve optimal results with Fast ABS-Like resin, you need to use the appropriate slicer profiles for your printer model and software. You can download the slicer profiles for Chitubox and Lychee slicers from this link: 3D Printing resin setting profile

Get started with the Siraya Tech V5 test model: Download the free Siraya Tech 3D printable test model here

  • Clean

Cleaning Step / Category

Instructions & Recommendations

Cleaning Solvents

• Preferred: 95% concentrated Ethanol or IPA.

• Alternative: Methanol (must not contain acetone).

Cleaning Time

Submerge parts in the solvents for 3-4 minutes, using the ultrasonic cleaner.

Extra Step

For complex model, use a painter brush (or any brush made with hair) to gently remove excess resin from the printed part.

 

  • Drying

Drying

Remove alcohol by using an oven for 4-5 minutes (Or using a hair dryer requires 10 minutes at least)

Note: For complex parts with cavities, repeat the clean/dry cycle multiple times.

Quality Check

Touch the dried surface. If it is still sticky, wash and dry the part again until smooth.

 

  • Post Curing

Step / Factor

Instructions & Recommendations

Pre-curing Checklist

Ensure the part is completely clean of excess resin and fully dry (no alcohol left) before starting.

UV Specifications

Use a UV light source with a wavelength of 395-405nm.

Curing Time

Cure for approximately 1-2 minutes to achieve optimal strength.