High Temperature Resistant Sculpt Grey and Clear TDS

1. Product Introduction

TheΒ High-Temperature Resistant Sculpt series includes three colors:Β Grey, Clear and Ultra White

Grey and Clear areΒ regularΒ versions ofΒ Sculpt Series.

Key Features

Sculpt Grey and Clear combine high resolution and low shrinkage to deliver the exact tolerances needed for accurate functional prototypes. Built for extreme environments, these engineering resins boast strong chemical resistance and can withstand high temperatures up to 180Β°C

Application:

  • Low-run injection molds
  • Vacuum forming
  • Dental Application
  • Artistic sculptures
  • Designed for vulcanized rubber process

Check out Sculpt High Temperature Resin here.

2. Property Data

Mechanical Properties

Measure

Method

Tensile Stress at Yield (Mpa)

39

ASTM D638

Tensile Stress at Break (%)

35

ASTM D638

Young’s Modulus (MPa)

3500

ASTM D638

Elongation at Break(%)

5

ASTM D638

Flexural Modulus (Mpa)

3300

ASTM D790

Flexural Stress at Yield (MPa)

40

ASTM D790

Flexural Strain at Break(MPa)

1.2

ASTM D790

Other Properties

Measure

Method

HDT at 0.455 MPa

160

ASTM D648

Shore Hardness (D)

90D

ASTM D2240

Solid Density g/cm3

1.2

ASTM 792

Water Absorption (24hr)

0.50%

ASTM D570

Refractive index (For Clear only)

1.5

ASTM D648

Liquid Properties

Measure

Method

Viscosity at 25Β°C (77Β°F)

650

ASTM D7867

Liquid Density

1.13

ASTM D1475

Β 

3. Work Flow

  • Clean

Cleaning Step / Category

Instructions & Recommendations

Cleaning Solvents

β€’Β Preferred: 95% concentrated Ethanol or IPA.

β€’ Alternative: Methanol (must not contain acetone).

Cleaning Time

Submerge parts in the solvents for 2-3 minutes, using the ultrasonic cleaner.

Submersion Limit

DoΒ notΒ submerge parts in alcohol for more thanΒ 5 minutes.

Extra Step

For a complex model, use a painter brush (or any brush made with hair) to gently remove excess resin from the printed part.
  • Drying

Drying

Remove alcohol by using an oven for 7-8 minutes (using a hair dryer requires 10 minutes)

Note: For complex parts with cavities, repeat the clean/dry cycle multiple times.

Quality Check

Touch the dried surface. If it is still sticky, wash and dry the part again until smooth.
  • Post-Curing

Step / Factor

Instructions & Recommendations

Preparation

Ensure the resin is completely cleaned off and absolutely no alcohol is left on the print before curing.

UV Specifications

Use a UV light source with a wavelength ofΒ 395-405nm.

Curing Time

Cure for approximatelyΒ 15 minutesΒ to reach optimal strength. Parts must be fully cured before use.

Recommended Method

Direct curingΒ withoutΒ water for moisture control.

Β 

More information：

Check outΒ Sculpt Resin User Guide

Download Sculpt Resin TDS in PDF Version